- Advertisement -

ES204 Filter Delay & Filter Chain X8187

Make magic with the Filter Chain X8187, which is no less than six exciting effects boxes in one unit. And add highly characteristic filtered delays with the ES204

ES204 Voltage Controlled Filter & Digital Delay incorporates two filters with CV control in the feedback loop of a digital delay circuit with times ranging from 0 to 4 seconds. Since the filters are placed within the feedback loop it’s possible to filter each repetition making anything a warm organic echo that can be pushed into screaming noisy mayhem. Do be aware of the feedback amount, it will self resonate on higher settings and when adding resonance to the filter the sound can get really load quickly! By minimising the delay and feedback to zero while having mix set to 100% the filter will act just as a regular high pass/low pass filter.

Filter Chain X8187 modules:

- Advertisement -

HighPass 2510 Cuts frequencies from 25Hz up to 10K. Comes with built in tube drive for juicy analog overtones. Frequency cut off can be modulated by CV input jack on the back panel.

LP3520 Cuts frequencies from 20k down to 35 Hz, The built in envelope follower can be used to modulate the cut off frequency and can also be routed via CV to other modules via the jack on the backside. The cut off frequency can also be modulated via the CV input jack on the back panel.

FreqShift 5K Shift frequencies inharmonically by Hertz either up, down or both (stereo). Range and Depth can be modulated by the jacks on the back panel. Direct in- and outputs for independent use or alternative routing.

SVF3022 State Variable Filter – slide seamlessly between LP/HP and Notch/Peak with the sliders. Adjust cut off frequency and resonance with the two knobs. Frequency cut off can also be modulated with CV via the jack on the back panel. Built in tube overdrive for heavy saturation.

DIGITAL ECHO))) Dual mode echo with built in filter and bit reduction. When MODE is lit the filter knob change from low pass to bipolar mode and filters either high or low frequencies from the feedback loop. Bit reduction happens inside the feedback loop when MODE is lit and after feedback loop when MODE is unlit. If Delat rate is set to 0ms and feedback to minimum the Bit reduction can be used on it’s own in the unlit MODE.

ATMOS REVERB Digital reverb – a mix of convolution technology and modelling. Sweep seamlessly between character from metallic to airy. Audio in- and outputs for alternative routing and independent usage.

PATCHLOADER Save and load patches for future usage. Input stage with transistor drive and level indicator, output with stereo level meters. Modules can be switched on or off (bypassed) with the six buttons below the display.

Pricing and Availability

These are two hot-off-the-press devices from Ekssperimental Sounds.  Be the first to try with 30% off intro offer! 

- Advertisement -